Good afternoon,
Can someone please sanity check something for me, one of the BEarena team is running a diagnostics test which is taking 7-8 minutes to deploy each diagnostics VM.
What is considered to be a normal amount of time?
At this rate the 8 node cluster will take over 1 hour to run diagnostics.
Thanks
Darryl
Solved
Diagnostics VM Time to Deploy - 4.0.2.1
+5Best answer by f3rm1n
I assume, from the day the op was created, that the diagnostics have run and finished...
However, for future reference, the KB linked above recommends:
1) The first one is to verify that ESX is configured correctly to look up against the correct DNS server. 2) If resolution 1 is not possible, you can edit ssh_config file on the hypervisor to include the following line at the bottom: useDNS no
View originalHowever, for future reference, the KB linked above recommends:
1) The first one is to verify that ESX is configured correctly to look up against the correct DNS server. 2) If resolution 1 is not possible, you can edit ssh_config file on the hypervisor to include the following line at the bottom: useDNS no
This topic has been closed for comments
+18- Nutanix Employee
- 82 replies
Check this article. It might be helpful to you.
https://portal.nutanix.com/#/page/kbs/details?targetId=kA0600000008cFQCAY
Hope it helps.
https://portal.nutanix.com/#/page/kbs/details?targetId=kA0600000008cFQCAY
Hope it helps.
+10- Nutanix Employee
- 25 replies
- Answer
I assume, from the day the op was created, that the diagnostics have run and finished...
However, for future reference, the KB linked above recommends:
1) The first one is to verify that ESX is configured correctly to look up against the correct DNS server. 2) If resolution 1 is not possible, you can edit ssh_config file on the hypervisor to include the following line at the bottom: useDNS no
However, for future reference, the KB linked above recommends:
1) The first one is to verify that ESX is configured correctly to look up against the correct DNS server. 2) If resolution 1 is not possible, you can edit ssh_config file on the hypervisor to include the following line at the bottom: useDNS no
+5That is exactly the issue we saw.
We'll be building this into our install process.
Thanks for the confirmation team.
We'll be building this into our install process.
Thanks for the confirmation team.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.