Windows NLB and Nutanix - how can i make it work | Nutanix Community
Skip to main content
Solved

Windows NLB and Nutanix - how can i make it work

Eric-The_Viking
Forum|alt.badge.img+3
Hi All

I have been asked by my dev team for Windows NLB to be enabled, I have had problems with this in a VMware environment, are there any gotchas, alternatives or tips to get this to work?

Many thanks

E.

Best answer by RichardsonPorto

Hi @Eric-The_Viking

I sent the VMware link because in your original post you mentioned that have problem with VMware environment, but since now you confirmed that you also need help for AHV, please open a support ticket and we can check your current setup and provide you the recommended configuration/setup.
View original
Did this topic help you find an answer to your question?
This topic has been closed for comments

7 replies

RichardsonPorto
Nutanix Employee
Forum|alt.badge.img+5
Hi @Eric-The_Viking

Can you confirm that you are using VMware vSphere ESXi hypervisor? If yes, you should refer to the VMware documentation on how to configure Windows NLB and a good start point is the following KB: https://kb.vmware.com/s/article/1006580


If you are using the Nutanix AHV hypervisor instead of VMware vSphere ESXi, please let me know and I can give you additional information about NLB and AHV.
Richardson Porto - LinkedIn: http://linkedin.com/in/richardsonporto
Eric-The_Viking
Forum|alt.badge.img+3
Hi Richardson Porto

Thank you for the VMware pointer, however in this case I am using AHV at my second site.
RichardsonPorto
Nutanix Employee
Forum|alt.badge.img+5
Hi @Eric-The_Viking

I sent the VMware link because in your original post you mentioned that have problem with VMware environment, but since now you confirmed that you also need help for AHV, please open a support ticket and we can check your current setup and provide you the recommended configuration/setup.
Richardson Porto - LinkedIn: http://linkedin.com/in/richardsonporto
Eric-The_Viking
Forum|alt.badge.img+3
Hi, I will have to request via Dell as I am not allowed direct access to Nutanix support as I am using Dell hardware. Many thanks

Eric
RichardsonPorto
Nutanix Employee
Forum|alt.badge.img+5
Hi @Eric-The_Viking

OK Eric, you are welcome and don't forget to provide all details including version of AOS and full NCC health check, since that can speed up the resolution.
Richardson Porto - LinkedIn: http://linkedin.com/in/richardsonporto
S
  • shabeer
  • Voyager
  • 1 reply
  • August 19, 2019
Hi RichardsonPorto,

I am having the same is there any recommendations to follow

my current environment details are below

AOS:5.10.4.1 LTS
Hypervisor:Nutanix 20170830.270
NCC:3.8.0.1
JeffLongley
Forum|alt.badge.img+5
  • JeffLongley
  • Adventurer
  • 3 replies
  • August 21, 2019
Currently got the same call in with support. According to this:
https://blogs.technet.microsoft.com/netgeeks/2017/07/13/the-nlb-deployment-reference-all-you-need-to-know-to-implement-and-deploy-microsoft-network-load-balancing/

Static ARP on the switches is the solution.

Assuming of course, your switches support it....
Terms & Conditions