Hello
Data replication, which was well done until yesterday, has stopped and is not progressing.
Only one of the five scheduled schedules will be suspended.
Note that the three entities that correspond to the schedule are excluded from the schedule for a while.
After increasing the cpu and memory, I included it again.
Is there any part or command I need to check?
This is a dark site, so remote assistance is not available.
Help me.
Hello
What is the Nutanix Cluster hardware specs and replication type, CVM resources, Hypervisor type? Is there any backup solution creates a snapshots for those VMs?
Aos 5.20.3.5 ,ahv20201105.2244
nx-3460,nx-8235
The number of vm is 12.
cvm resource is 36Gb
Thank you
NX-8235, is it a 2-node cluster?
It consists of three nodes. Rather than this question,
I checked that one of the asyncdr in the dr cluster is active and this seems to be the problem.
How do I change it to inactive?
It consists of three nodes. Rather than this question,
I checked that one of the asyncdr in the dr cluster is active and this seems to be the problem.
How do I change it to inactive?
So you have two active sites in de data protection?
you cant make it inactive. Remove it and cleanup the created virtual machines (they should be turned off already) and the active (original cluster) data protection will create the “inactive” one again.
I checked that it was disconnected because the communication settings between the cvm and the customer's network were different Thank you for your help
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
