Hi everyone, I have an NX-3460-G6 that was turned off yesterday by accidentally unplugging the power cables. I tried to turn it back on, but the power supplies (PSU) have green LEDs flashing (the other LED is off). Now from the documentation I see that it could be one of two causes: 1) "When AC is present only: 12VSB on (PS off) of PS in sleep state (the LED should flash at i Hz). 2) Power supply firmware updating mode (the LED should flash at 2 Hz).
PS NX-3460-G6
This topic has been closed for comments
Hi everyone. I'll ask the question again, trying to be more clear. I have an NX-3460-G6 that shut down yesterday when I accidentally unplugged the power cords. I tried turning it back on, but the power supplies (PSU) have flashing green LEDs (the other LED is off). Now from the documentation I see that it could be one of two causes: 1) "When only AC is present: 12VSB on (PS off) of the PS in sleep state (LED should flash at i Hz). 2) Power supply firmware mode update (the LED must flash at 2 Hz). How do I turn the nutanix back on in case 1? How do I upgrade the firmware if it doesn't turn on (case 2)?
Userlevel 1
+1
Do you have IPMI access? You will likely need the IPMI interface in order to troubleshoot further.
from IPMI access you can update BIOS and BMC firmware, check the BIOS battery for voltage.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.