Our CVMs are locked down tight, I have no intention of allowing any internet access to PE, all support actions must be done through a webex session where our admin grants control to the support tech.
but I have PC set up for NAT so it can communicate outside our private network. my question is, will pulse work strictly through PC or does PE need to be set up for it? Everything i see documented is about PE talking to insights.nutanix.com.
Pulse: PE or PC?
This topic has been closed for comments
Starting in AOS 5.6.1 with NCC 3.5.2, Prism Central should by default act as a Proxy for any connected PE clusters that have Pulse enabled. There is no configuration required beyond enabling Pulse in PC and enabling Pulse in PE.
Make sure that there is NO manual proxy configuration in the PE.
Here is the official documentation:
https://portal.nutanix.com/#/page/docs/details?targetId=Prism-Central-Guide-Prism-v511:mul-pulse-proxy-server-c.html
The logic on the PE looks like the following:
Make sure that there is NO manual proxy configuration in the PE.
Here is the official documentation:
https://portal.nutanix.com/#/page/docs/details?targetId=Prism-Central-Guide-Prism-v511:mul-pulse-proxy-server-c.html
The logic on the PE looks like the following:
OK, This is very helpful, it appears as though I have a boat load of options:
I think the idea here is, in order to leverage PC for Pulse, is to remove the proxy from PE, and then configure it in PC, or, simply open up outbound communications from PC to Nutanix.
- Although I have the CVM cluster locked down behind a firewall, I can always open it for communication to our proxy server, which is then allowed outbound only
- Instead of HTTP proxy from the cluster, I can use PC for Pulse, and can use it in the following ways:
- PC can use pulse via NAT to reach Nutanix
- PC can use HTTP proxy to reach Nutanix
- PC can use SMTP
I think the idea here is, in order to leverage PC for Pulse, is to remove the proxy from PE, and then configure it in PC, or, simply open up outbound communications from PC to Nutanix.
Yes, your understanding is correct. You'd remove the proxy configuration from the PE. Then PE would automatically use the PC for sending pulse data.
PC would in turn send that data out over whatever mechanism is available.
PC will try to directly reach the destination (or use your configured proxy). If those mechanisms don't succeed, then it will send data using the configured SMTP server. You can find more info in the Prism Central guide here: https://portal.nutanix.com/#/page/docs/details?targetId=Prism-Central-Guide-Prism-v511:mul-support-pulse-recommend-pc-c.html
PC would in turn send that data out over whatever mechanism is available.
PC will try to directly reach the destination (or use your configured proxy). If those mechanisms don't succeed, then it will send data using the configured SMTP server. You can find more info in the Prism Central guide here: https://portal.nutanix.com/#/page/docs/details?targetId=Prism-Central-Guide-Prism-v511:mul-support-pulse-recommend-pc-c.html
Thanks Jason - much appreciated. I have worked with VMware FC storage for over 25 years, brand new to nutanix and WOW I feel like I have to learn all over again.. fun fun.. sadly the one thing I find that remains true after all these years is that documentation rarely presents us all the architectural answers to our questions and is still focused on basic configuration in most cases, so I appreciate the assistance with the understanding of the greater architecture. I will have more questions over the next few weeks so I hope I don't annoy you guys too much 🙂
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.