Hi everyone, I have an NX-3460-G6 that was turned off yesterday by accidentally unplugging the power cables. I tried to turn it back on, but the power supplies (PSU) have green LEDs flashing (the other LED is off). Now from the documentation I see that it could be one of two causes: 1) "When AC is present only: 12VSB on (PS off) of PS in sleep state (the LED should flash at i Hz). 2) Power supply firmware updating mode (the LED should flash at 2 Hz).
This topic has been closed for comments
Hi everyone. I'll ask the question again, trying to be more clear. I have an NX-3460-G6 that shut down yesterday when I accidentally unplugged the power cords. I tried turning it back on, but the power supplies (PSU) have flashing green LEDs (the other LED is off). Now from the documentation I see that it could be one of two causes: 1) "When only AC is present: 12VSB on (PS off) of the PS in sleep state (LED should flash at i Hz). 2) Power supply firmware mode update (the LED must flash at 2 Hz). How do I turn the nutanix back on in case 1? How do I upgrade the firmware if it doesn't turn on (case 2)?
+1Do you have IPMI access? You will likely need the IPMI interface in order to troubleshoot further.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.