Skip to main content
Hi

I have aplan to reconfigure the ip addressess of all Nutanix components (hypervsors ip's ,CMV's and cluster ip. My question is what is the priority of changing ip's ( start point) and what is the worst scenario through this process?





Regards
Theres a section for this in the production documentation.



Basically, it involves putting the cluster into a reconfiguration mode, and it will change them all for you.



Jon
I'm asking about priority please: Are below steps in correct priorities?

1.cluster stop

2.cluster reconfig

3.

ncli cluster set-external-ip-address external-ip-address="cluster_ip_address" 4.go to http://cvmipaddr:2100/ip_reconfig.html and provide

CVM subnet mask

CVM default gateway

and new address for CVM

5.cluster start
Have you read through the product doc for this?



https://portal.nutanix.com/#/page/docs/details?targetId=Advanced_Admin-Acr_v4_6:ip__ip_reconfig_web_c.html



You should use that as your guide
Good document .Thank you
Thanks...but as a newbie just trying out the community edition and trying to get started it´s very hard to go forward.

Almost all proper information is "hided" behind the activation of the support portal.

All links that i found i cannot access because i have no serial yet.



Thanks to make it so hard to start 😞.
ChristianTroll - have you seen our Community Edition forum? We have an entire section of this website dedicated to CE, with a ton of proper information.http://next.nutanix.com/t5/Discussion-Forum/bd-p/DiscussionIf you are having any issue with CE, please make a post there and we'll be happy to help you.
Terms & Conditions