Phoenix Installation Directly on a Node

It is much easier to foundation the single node with the correct versions.  

im installing AOS version 6.5.1.6 on a 2 node cluster but it ends up in the result says “Warning skipping <ImagingStepRAIDCheckPhoenix(<NodeConfig(IP) because dependencies not met, failed task: [<ImagingStepInitIPMI(<NodeConfig(IP)>)]” so now Im resorting on phoenix imaging 1 node at a time but i dunno the next steps when i reach root@phoenix

it's like the issue in here: AOS installation failed with error "Failed to register internal hypervisor" and "because dependencies not met" | Nutanix Community

Hey,

Yeah, I had to do this recently because I couldn't use Foundation.

Did you generate the Phoenix ISO, including the hypervisor image etc.?

You shouldn't land at a prompt, it should boot into an installer.

hmmm i just downloaded and tried Phoenix ISO only both from the portal and generated version but ends up in the prompt, sorry, so i need to use phoenix ISO and ahv ISO at the same time in 1 bootable usb drive? pls guide me.

thanks much for this @Kcmount  will check this out once get back to the office

No worries :) 

Hello @Kcmount actually the HW model is Supermicro SYS-6029P-TR but its not validated by Nutanix itself as it wasn’t came from Nutanix validation and Hardware test. is there any implication with regards to that?

BTW I haven’t tested the commands you gave to me yet but will update you once I do. thanks much sir!

Hey, not sure if it will work but its worth a try :)