Imaging with foundation failed with error shown required NOS tarball.
But all NOS phoenix downloaded from portal is on .ISO format.
Kindly advice please.
Solved
Foundation 3.+ required tarball NOS?
+9Best answer by Jon
Foundation 3 doesn't require separate phoenix ISO's anymore, that was only foundation 2.x.
Foundation 3 just requires the NOS "tarball" upgrade file, the same image file you'd use to upgrade a running cluster.
Check out the field install guide for 3.x, and it's all covered in there.
Foundation 3 just requires the NOS "tarball" upgrade file, the same image file you'd use to upgrade a running cluster.
Check out the field install guide for 3.x, and it's all covered in there.
This topic has been closed for replies.
+29- Nutanix Employee
- 547 replies
- Answer
Foundation 3 doesn't require separate phoenix ISO's anymore, that was only foundation 2.x.
Foundation 3 just requires the NOS "tarball" upgrade file, the same image file you'd use to upgrade a running cluster.
Check out the field install guide for 3.x, and it's all covered in there.
Foundation 3 just requires the NOS "tarball" upgrade file, the same image file you'd use to upgrade a running cluster.
Check out the field install guide for 3.x, and it's all covered in there.
+9In my Hyper-v Nutanix cluster , i run the command hostips on cvm.
But the hypervisor host ip it showing incorrectly.
How do i sync the host ip with my cluster?
I have tried cluster stop and cluster start.
allssh genesis restart.
But still problem persist?
hostips doesnt show correct ip on a host.
But the hypervisor host ip it showing incorrectly.
How do i sync the host ip with my cluster?
I have tried cluster stop and cluster start.
allssh genesis restart.
But still problem persist?
hostips doesnt show correct ip on a host.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.