Async DR Ports
What ports i need to open on the FW in able to use async dr between two remote sites?
This topic has been closed for replies.
+17- Nutanix Employee
- 45 replies
Hello
The ports can be specified in the Nutanix "remote site" configuration, but the default will be ports 2009 and 2020.
Thanks,
Mike
The ports can be specified in the Nutanix "remote site" configuration, but the default will be ports 2009 and 2020.
Thanks,
Mike
+15- Nutanix Employee
- 23 replies
Hi
Yes. The Cerebro master (2020) can be any node (and moves around due to CVM reboots for patches or whatnot) so this can and will change.
The Stargate port (2009) is needed for any replication - after Cerebro sets it up using 2020 the Stargates on each side will talk directly to each other to sync the data.
Yes. The Cerebro master (2020) can be any node (and moves around due to CVM reboots for patches or whatnot) so this can and will change.
The Stargate port (2009) is needed for any replication - after Cerebro sets it up using 2020 the Stargates on each side will talk directly to each other to sync the data.
+15- Nutanix Employee
- 23 replies
Hi
{edit: those ports were for other things, sorry about that!}
Check out http://vmwaremine.com/2014/09/19/nutanix-network-port-diagram/#sthash.Bygiho60.BzfnPmXy.dpbs for a full port mapping
{edit: those ports were for other things, sorry about that!}
Check out http://vmwaremine.com/2014/09/19/nutanix-network-port-diagram/#sthash.Bygiho60.BzfnPmXy.dpbs for a full port mapping
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.