+2Hello,
I have recently deployed nutanix with Foundation, and every went well and I can access the PE from web browser. But when I go the Virtual Switch section, I cannot See vs0 in Switch Tab, not sure what is the issue. I go to Cluster Setting and Reboot the cluster, but it keep on processing and so on entering in maintenance mode. Can anyone help.
Regards
+3Hi
This could be due to networking not initializing correctly. If this is a lab or a fresh setup, it’s usually better to rerun Foundation with the correct network configuration instead of trying to fix it manually.
You can also check the following:
Verify if vs0 exists:
ovs-vsctl show
Look for: Bridge "vs0"
Check uplinks and NIC mapping:
manage_ovs show_uplinks
host_nic_list
Test connectivity between CVMs:
ping <CVM IP>
Thanks
Selvamani.S
+8Hi,
during vs0 setup maybe there was some hickup with the network. For example when the gateway is not reachable during vs0 setup it may fail. if it is possible exit maintenance modes and retry adding vs0 through PC.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.