Stop Hypervisor Got Error | Nutanix Community
Skip to main content

when I shutdown the hypervisors using sshs and run below command getting as below . why?

Last login: Thu Aug 24 10:52:52 2023 from 148.179.254.56


Nutanix AHV is a cluster-optimized hypervisor appliance.

Alteration of the hypervisor appliance (unless advised by Nutanix
Technical Support) is unsupported and may result in the hypervisor or
VMs functioning incorrectly.

Unsupported alterations include (but are not limited to):

- Configuration changes.
- Installation of third-party software not approved by Nutanix.
- Installation or upgrade of software packages from non-Nutanix
  sources (using yum, rpm, or similar).

shutdown -h now
exit
]0;root@NTNX-0b05f232-A:~~?1034hhroot@NTNX-0b05f232-A ~]# shutdown -h now

Hi,

Whats the error in the output?

F>P


Muy Buenas, este hilo como va ? Tengo exactamente el mismo error, no puedo acceder al AVH y tengo todas las maquinas paradas. 


Muy Buenas, este hilo como va ? Tengo exactamente el mismo error, no puedo acceder al AVH y tengo todas las maquinas paradas. 

If you have all the machines stopped you can acces ahv via ssh or ipmi/idrac/ilo. 


I cannot access the AHV, I can only access the host, it also tells me that the CVM is running.

AHV is the host. 

To shutdown a cluster and hardware follow the following steps: https://portal.nutanix.com/page/documents/details?targetId=AHV-Admin-Guide-v6_7:ahv-cluster-shut-down-t.html