5 Essential Tips for Maximizing Your Experience at Nutanix .NEXT for Bloggers
Hello fellow Nutanix fans,We have a three-node cluster in a DR location. This DR cluster has less capacity than the primary site which has resulted in us exceeding the resilient capacity of the DR cluster.To remedy this situation, we decided to replace four 8TB HDDs with four 12TB HDDs in each node. Today we removed one drive from a node in Prism UI and waited approximately four hours before the system reported it was safe to remove the drive. During this time, Prism reported that data was lowering on the drive. The cluster showed about 700MB/s of throughput during this rebuild, which seems pretty really good for a cluster of this size. We removed the 8TB HDD and inserted the 12TB HDD. The rebuild did not initiate until we ran NCC. By default, NCC runs every 24 hours so, eventually the rebuild would have started but, we wanted to see it get started.We watched the rebuild run for a while after it got underway. The system is writing around 80MB/s to the replacement drive. At this rate (2
We keep our test cluster up-to-date with the latest STS versions.Unfortunately, by doing so, I cannot upgrade from 6.0.2.5 to 6.1 as it is not supported.Upgrading from 6.0.2.4 is supported.I have two questions, one, when will I be able to upgrade to 6.1 from 6.0.2.5?Second, should I lag a version or two behind in the STS track to make sure I am not blocked from taking a major upgrade?Thanks!
Already have an account? Login
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
Sorry, we're still checking this file's contents to make sure it's safe to download. Please try again in a few minutes.
Sorry, our virus scanner detected that this file isn't safe to download.