The NICs are connected, not sure why its failing. Anyone knows? I have tried with foundation 4.6 and 4.5.4.2 . The Nics are connected an Intel with dell firmware 19.5.12. Existing cluster is running fine with same specs.
Page 1 / 1
Hi
These errors are spotted if connected gbic transceivers in our 10gb interfaces. This can cause ethtool report 10/100/1000 speeds inaccurately, causing phoenix / foundation to fail with the error shown in the description.
Could you. please confirm the speed of the interface with the help of the following command
ethtool eth<interface>
Also please confirm if the drivers are loaded correctly with the help of the following command
lspci -m
Thanks Neel.
I used foundation 4.4.4 and the re-image actually went through! I have double checked, and the speed is 10gb. Not sure why this version worked and the latest didn’t..
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.