I’m attempting a new installation of CE. The installation itself completes with no apparent errors but I can’t connect to either the AHV or CVM IP’s assigned during the install. The onboard server NIC is a four port HPE 331i which has a Broadcom chipset. Three of the ports are connected to the same network vlan that the IP addresses are tied to. I have tried trunking them on the switch side, leaving them all on as individual ports and enabling/disabling each so that only one connects at a time and have had no luck with any of these strategies. I’ve tried to log into the console of the CE server but haven’t been able to find credentials that work. Any ideas would be much appreciated since I’m so close to be done hopefully.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.