Change Fault Tolerance Domain To Block Or Not?

  • 7 November 2020
  • 1 reply

Userlevel 1
Badge +2

Hi everyone,

If you have 5 blocks with 8 nodes installed in the same rack, will you keep using RF = 2 or 3, or will you use fault tolerance domain to block instead?

This topic has been closed for comments

1 reply

Userlevel 2
Badge +3

Hello Wei,

Policies like Redundancy factor and Fault tolerance are often best implemented based on the setup, requirement and use-case of the environment and on a case by case basis. 

I would like to suggest you to go through this document: and decide which would suit better for your setup.

You can focus on the Block awareness section of this document: and evaluate if it would be a good idea to move the fault tolerance domain to Block type.