Modify Desired Fault Tolerance Domain Without Prism UI

Hi all,

I’m running a single node cluster, and while I was poking around the settings I went into the Rack Configuration page and set the fault tolerance level to node.

Of course with it being a single node cluster the dashboard now shows warnings that the cluster can’t self-heal from a node failure.

I’m not able to find an option to change the desired fault domain back down to disk, I can’t find any commands that do anything other than get what it is currently.

Obviously my particular desire to lower the fault tolerance domain below node isn’t something that’s an intended use for this software; but is there really no way to change these settings configuration outside of prism?

0 replies

Be the first to reply!