Hi guys, I have 3 node 1065 G7 cluster 5.20 and planning to upgrade to 6.5.1.6. Post I am adding 1065 G8 to the existing. Is there any issues if I image the 1065 G8 to 5.20 then add it to the cluster and upgrade all together tp 6.5.1.6?
Page 1 / 1
Is it ok to connect the cables to the production switch where existing cluster for imaging or should I have an unmanaged switch?
Hi guys, I have 3 node 1065 G7 cluster 5.20 and planning to upgrade to 6.5.1.6. Post I am adding 1065 G8 to the existing. Is there any issues if I image the 1065 G8 to 5.20 then add it to the cluster and upgrade all together tp 6.5.1.6?
Hello
| Configuration | Description |
|---|---|
| Same AOS and hypervisor versions | The node is added to the cluster without reimaging it. |
| Same hypervisor version but different AOS version | The node is automatically reimaged before it is added. However, if the AOS version on the node is higher than the version on the cluster, you can upgrade the cluster to the higher version. If you do not upgrade the base cluster to match the node AOS version, the node is reimaged automatically to match the lower AOS version of the cluster. For more information about how to upgrade your cluster, see the Acropolis Upgrade Guide. |
| Same AOS version but different hypervisor version | The node is automatically reimaged before it is added. |
Is it ok to connect the cables to the production switch where existing cluster for imaging or should I have an unmanaged switch?
Hello
Discovery requires that IPv6 multicast packets are allowed through the physical switch. If you see a failure message, review the requirements in Prerequisites and Requirements.
So the recommended solution is upgrade the cluster and expand the cluster?
Is it ok to connect the cables to the production switch where existing cluster for imaging or should I have an unmanaged switch?
Hello
Discovery requires that IPv6 multicast packets are allowed through the physical switch. If you see a failure message, review the requirements in Prerequisites and Requirements.
So should I connect all ports of nutanix to switch during initial configuration?
So the recommended solution is upgrade the cluster and expand the cluster?
yes
Is it ok to connect the cables to the production switch where existing cluster for imaging or should I have an unmanaged switch?
Hello
Discovery requires that IPv6 multicast packets are allowed through the physical switch. If you see a failure message, review the requirements in Prerequisites and Requirements.
So should I connect all ports of nutanix to switch during initial configuration?
yes
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.