Hello folks,
I installed a 3node cluster with hyper-v on 1Gig interfaces. Now I want to "migrate" this setting to 10gig interfaces. If i disconnect the 1gig interfaces and plugin the 10gig interfaces the host disconnects and no services are functional. I have to disconnect the 10gig interfaces and reconnect the 1gig interface to reach the host/cluster.
Is there a document which describes the procedure to change 1gig to 10gig interfaces? Or could anybody give me some advice?
If i check the nic teaming on the hyper-v hosts there are 4 interfaces (2x1gig, 2x10gig) added to the NetAdapterTeam.
Best regards,
Freddie
This topic has been closed for comments
+1
Hi, I would try following:
- Add 10G interfaces to the 1G team first
- Verify status of 10G interfaces is up
- Verify 10G interfaces are on same VLAN i.e. on Hyper-V if tagged and switchports as well
- Disconnect 1G ports
- Confirm if all is ok
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.