The NICs are connected, not sure why its failing. Anyone knows? I have tried with foundation 4.6 and 4.5.4.2 . The Nics are connected an Intel with dell firmware 19.5.12. Existing cluster is running fine with same specs.
Page 1 / 1
Thanks Neel.
I used foundation 4.4.4 and the re-image actually went through! I have double checked, and the speed is 10gb. Not sure why this version worked and the latest didn’t..
Hi
These errors are spotted if connected gbic transceivers in our 10gb interfaces. This can cause ethtool report 10/100/1000 speeds inaccurately, causing phoenix / foundation to fail with the error shown in the description.
Could you. please confirm the speed of the interface with the help of the following command
ethtool eth<interface>
Also please confirm if the drivers are loaded correctly with the help of the following command
lspci -m
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.