When installing ce-2020.09.16.iso, I get an error about: hdparm
StandardError Failed Command [hdparm -z /dev/sda] with reason [BLKRRPART Device or resource busy]
My config is as follows:
- Intel PC (Optiplex 9020)
- USB disk with the .iso to boot from
- A single Harddisk to do the installation on
This is reproducable on an Intel-NUC, exact the same issue..
Now, I add an additional Harddisk (two HDs and one USB). Note that both HD’s are not carrying any nutanix data, format or whatsoever.
After the boot I get a different error:
Phoenix: ISO is already mounted
FATAL: Couldn’t find a hypervisor and an AOS installed, please package phoenix with a hypervisor and a AOS. Please refer to Nutanix support portal for more information about this.
Why do I get an hdparm error in the first place.
When adding a disk, apparently to get around the hdparm error, I suppose that the ce-2020.09.16.iso supposed to provide me the hypervisor and all this.
Not sure if the hdparm error is related.
Furthermore, the document Nutanix-Community-Edition-Getting-Started.pdf describes an installation using a ce.img, while the latest version is an .iso file. I get the impression that this document is not up to date.
There is a discussion about the same issue on the Next community. Can you please check the below link:
Else Search for “Attempting initial installation receive error: An error occurred while trying to illuminate the chassis LED“ post on next community.