Hi Team ,
Whenever i try to validate my Nutanix 3 node cluster at failover manager , it hangs.
Kindly assist / advise please.
This topic has been closed for comments
+3
Thanks Mike!
Userlevel 3
+17
- Nutanix Employee
- 45 replies
-
28 November 2016
Hello,
It's expected for windows failover cluster validation to fail. Failure is due to the internal network and the duplicate IPs used for that network across the nodes in the cluster. We have a KB which discusses the problem here: https://portal.nutanix.com/#/page/kbs/details?targetId=kA0600000008gajCAA
Thanks,
Mike
It's expected for windows failover cluster validation to fail. Failure is due to the internal network and the duplicate IPs used for that network across the nodes in the cluster. We have a KB which discusses the problem here: https://portal.nutanix.com/#/page/kbs/details?targetId=kA0600000008gajCAA
Thanks,
Mike
+3
Hello,
I also have this issue of cluster validation fails as well.
Everything will pass if I omit Network Communications.
Is this normal?
Thanks.
Regards,
Tze Siong
I also have this issue of cluster validation fails as well.
Everything will pass if I omit Network Communications.
Is this normal?
Thanks.
Regards,
Tze Siong
Userlevel 6
+29
- Nutanix Employee
- 569 replies
-
26 February 2016
1 - Can you post specific details about your setup and configuration?
2 - Can you post screenshots?
3 - Have you opened a support ticket?
2 - Can you post screenshots?
3 - Have you opened a support ticket?
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.