Solved

Node position Blank

  • 20 May 2016
  • 3 replies
  • 1266 views

Badge +4
Hi Stupid question of teh day
Is there a knack of removing the node blank from the chassis?
I have tried several ways and it doesnt move - tried pushing the tabs in and pulling /pushing the blank but it doesnt move - cannt see that it is screwed in place or anything.
Must be able to remove in case you want to install a 4th node.

thx
Nick
icon

Best answer by nickwall 26 May 2016, 16:10

The Blank was pushed into the chassis too far - we managed to get it out eventually - so all good now
Cheers
View original

3 replies

Userlevel 7
Badge +30
AFAIK, you should just have to push the tabs in, and pull it in reverse.

Worst case, open a support ticket with us, and we'll put our heads together if there is something funky going on.
Badge +4
The Blank was pushed into the chassis too far - we managed to get it out eventually - so all good now
Cheers
Userlevel 1
Badge +14
I encoutered the same question once, the empty blank is pushed too deep from factory. and it`s hard too pull out it , you should pull with more strength

Reply