Best answer by rborey
View originalNCC upgrade queued
I attempted an upgrade of NCC however it is stuck. Is there a way to restart the upgrade?
This topic has been closed for comments
Found a solution!
Log into a CVM and then run the command
progress_monitor_cli --fetchall
find the entity id and then run this command
progress_monitor_cli --entity_id= --entity_type=node --operation=upgrade_ncc --delete
"node" and "upgrade_ncc" should be the same, but verify and make sure that they are lower case and you dont include the "k" from either one. There might be more than one entity_id, so repeat for each (if its queued on more than one node).
Log into a CVM and then run the command
progress_monitor_cli --fetchall
find the entity id and then run this command
progress_monitor_cli --entity_id= --entity_type=node --operation=upgrade_ncc --delete
"node" and "upgrade_ncc" should be the same, but verify and make sure that they are lower case and you dont include the "k" from either one. There might be more than one entity_id, so repeat for each (if its queued on more than one node).
Thanks @sandeepmp , I ran the commands you suggested however the upgrade is still queued.
Thank you for sharing this! I will try this as soon as possible and give a feedback.
ssh to cvm 10.1.1.77
check clusterhealth status by running below command
genesis status | grep -i health
if no pids, run “cluster start”
if pids are shown,
genesis stop cluster_health
cluster start
this should fix your issue
Still looking for a way to resolve this.
Hi @brightcoveIT
Are you still facing this issue?
I'm bumping this post back up. Hoping to get some fresh eyes on it.
Are you still facing this issue?
I'm bumping this post back up. Hoping to get some fresh eyes on it.
Same Problem for me.
Is there any other solution for this?
Is there any other solution for this?
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.