Solved

Change cluster IP address without IPv6 access - round and round...

  • 15 October 2018
  • 1 reply
  • 383 views

Userlevel 2
Badge +3
Good evening All

I have been through the IP reconfigure process for my 3 hosts and 3 cvms, which seemed to be straight forward, however Prism is not starting and I am unable to change the Cluster IP address - the main physical switches have been change and no longer have the old IP range to access by original IP address. The document says go here if you don't have IPv6 but it just sends me back to the same document containing the use IPv6 instructions. Can someone help, this is driving me nuts. If there is not a way to change the IP address is there a way to remove the original cluster and Prism Central and replace with a new one?

Thanks
icon

Best answer by Eric-The_Viking 21 October 2018, 23:27

Hi All

I worked this one through myself, I had managed to get the Cluster stuck in reconfigure mode and once it was unstuck and a restart took place, I was able to launch the virtual Prism console and change the IP. The only problem i still have is that I am unable to start the Prism Central VM. I can see the VM in Prism but not at the CLI. Any ideas anyone?
View original

1 reply

Userlevel 2
Badge +3
Hi All

I worked this one through myself, I had managed to get the Cluster stuck in reconfigure mode and once it was unstuck and a restart took place, I was able to launch the virtual Prism console and change the IP. The only problem i still have is that I am unable to start the Prism Central VM. I can see the VM in Prism but not at the CLI. Any ideas anyone?

Reply