Best answer by Jon
View originalAdditional IP to cluster
Hi, Is it possible to assign additional IP to nutanix cluster? Scenario is as follows: 1. Having network class A with 10.x.x.x which is used for CVM, hypervisor communication during configuration. 2. Cluster virtual IP is also from 10.x.x.x range. 3. Added additional IP range of 172.x.x.x to CVM, Hypervisor. 4. Is it possible to add additional IP range IP of range 172.x.x.x to cluster virtual IP? Thanks
This topic has been closed for comments
Ahhhh, I see!
ok, that makes sense. Alright, yes, those ports would need to be open site to site.
ok, that makes sense. Alright, yes, those ports would need to be open site to site.
172 using 1G separate & 10 using 10G
So is the 172 network coming in over the same 10GbE interfaces? or some other separate interfaces, like the onboard 1GbE ones?
Can't. 10.x.x.x is using for data services & replication between CVMs.
This may sound silly, but if you're going to expose the CVM's to both side of the network, why not just simplify and drop the 10.x network and run the CVM's on the 172 network
We have separate network for Internet (172.x.x.x) & Data traffic (10.x.x.x & not routable) CVM are using data network for communicating with each other & service NFS on 10.x.x.x network. Cluster IP is of 10.x.x.x network. Second network is using IP from 172.x.x.x range with is routable & can be access from outer network. Need to configure Remote site which is only accessible from 172.x.x.x network.
I'm 99% positive we do not allow a secondary VIP
If you absolutely require it, it may be worth while to put the "Primary" network as this "new" set of IP Addresses and assign your VIP that way
That all said, whats the use case here? Why do you need to IP Address your system twice over?
If you absolutely require it, it may be worth while to put the "Primary" network as this "new" set of IP Addresses and assign your VIP that way
That all said, whats the use case here? Why do you need to IP Address your system twice over?
Hi, Thanks for inputs. Already assigned secondary IP & interface for CVM. But how to mention secondary IP for cluster?
Check this KB out: https://portal.nutanix.com/#/page/kbs/details?targetId=kA0600000008i7qCAA
Hi, Is it possible to point me to process steps. Currently running 4.7.1
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.