Installation & Configuration

Welcome to the Nutanix NEXT community. To get started please read our short welcome post. Thanks!

cancel
Showing results for 
Search instead for 
Did you mean: 

need to config dot1q trunk for bond0 interface or not?

SOLVED Go to solution
Wayfarer

need to config dot1q trunk for bond0 interface or not?

Picture1.pngmy question is form this senario

if host "VM1" belong to vlan 10 and host "VM2" belong to vlan 20

"CMV"&"AHV" on vlan 1 (untag)

 

i need to config trunk on bond0 interface or it done by automatic?

1 ACCEPTED SOLUTION

Accepted Solutions
Nutanix Employee

Re: need to config dot1q trunk for bond0 interface or not?

The bond is configured as a trunk automatically.  You will only have to create the vlan 10 and vlan 20 networks in AHV then forwarding will work as expected.

2 REPLIES
Nutanix Employee

Re: need to config dot1q trunk for bond0 interface or not?

The bond is configured as a trunk automatically.  You will only have to create the vlan 10 and vlan 20 networks in AHV then forwarding will work as expected.

Wayfarer

Re: need to config dot1q trunk for bond0 interface or not?

thx for you suggesstion.